Item #: SAST-D0008DRW
*Backordered: 9/15/2021
  • About This Product
  • Reviews
  • Install And Tech Information


With greater frequency we have listened as customers would ask for manual locking front hubs for their Dodge Ram truck.

The primary benefit of the SpynTec hubs are reduced wear on the front drivetrain: the axle shafts and corresponding differential gearing are disengaged. Other benefits: fuel economy thanks to the elimination of 150-pounds of rotating mass, universal joint wear is all but eliminated and the bearing are serviceable whereas the OEM bearings are not.

All SpynTec™ Industries hubs start out as steel forgings and not castings like other manufacturers. Hubs are turned and sent off to the gear cutter for the internal splines and the gear cut external ABS tone rings. The hubs are finally bright zinc plated for a durable finish.

Spindle forgings are rough turned, heat treated, then final machined. This is the only way to guarantee a spindle with minimal run-out.

And rather than sending you a box of parts, SpynTec™ Industries partially assembles every kit. When your kit arrives, the studs and races are pressed in the hubs, spindle bearings are installed in the spindles, and axle slingers are installed on the axle shafts.

The SpynTec kit for your '00-'08 Ram truck with dual rear wheels includes:

  • Forged hubs with gear cut ABS tone ring.
  • Forged spindles with integral ABS sensor mount.
  • Includes all bearings, races , seals, and spindle nuts.
  • Premium locking hubs.
  • Wheel Studs
  • 35-Spline Stub Shafts
  • Installation Directions
We're excited to offer the SpynTec designed front manual hubs.

NOTE: If you are running aftermarket wheels or aluminum wheels, the wheels center bore needs to have a minimum 4.224" bore to accommodate the hubs.


Write a review
Worth the money
Feb 8, 2021  |  By Curr
I transport rv's for a living. I put over 150,000 miles on these hubs so far, definitely worth every penny. No issues so far. As far as mpg gain, I've not noticed hardly any but I have gained peace of mind knowing front diff, t-case and front driveshaft are not constantly turning for no reason.

Free Wheel Spin Kit
Mar 1, 2017  |  By Ken Sposato
This kit is great! I waited and am writing this review after accumulating over 60,000 miles on it. NO issues at all. My only recommendation is replace the axle shaft u-joints while you are at it.

Spyntec DRW
Nov 7, 2016  |  By Michael Gowan
Everything went together well. One set of bolts was not included and that was the bolts to fit the brake rotor to the hub.
Owner Response:We are sorry that all the bolts were not included from Spyntec. I will be contacting you to see if this has been taken care of for you yet.

Install and Tech Information

Download Spyntec Hub Installation Instructions.pdf