REBUILDABLE BALL JOINT KIT (**OVERSIZE**) - EMF ('03-'09, 2500/3500 4WD)

Item #: EMF-7467.1-7460.1
  • About This Product
  • Reviews


'03-'09 Ram ball joint replacement: There aren't many truck projects that are as unpleasant. It is dirty, difficult and time consuming job.

To accomplish that goal, you need a rebuildable ball joint. The folks at EMF (Evolution Machining and Fabrication) have developed "a better mousetrap." Here is the sales pitch: EMF is a small specialty shop. They make rebuildable Heim joints, rod ends, tie rods and ball joints.

The EMF Ball Joint has a removable race and pin (part of their patent). Competitive products have a removable pin, however the inside of the housing will wear as the pin wears resulting in the inevitable replacement of the entire unit. By having the internal race and pin set on the EMF ball joint, the race will act as the wear point instead of the housing body creating a long lasting unit.

Over time, the ball joint pin and races will wear and when it gets to the point where the play can't be removed by tightening it anymore - that's when you rebuild it. You don't have to remove the ball joint from the knuckle - you can rebuild them right on the truck.

This oversize ball joint kit is offered to accommodate worn out or larger knuckle holes caused by frequent changing of prior ball joints or the previous use of knurled bad joint housings that stretched the housing hole. The outside diameter of the housing is machined 10 thousands oversize than OEM.

Included in the EMF Ball Joint Kit for Ram trucks with radius arms:

  • 1 Pair of Oversized Upper Ball Joints
  • 1 Pair of Oversized Lower Ball Joints
  • Install Nuts
  • Install Washer & Cup (To avoid damaging the cap and the ring when pressing the ball joint into the knuckle)
  • Allen Key & Spanner Wrench (To Tighten the Ball Joints or Rebuild them in the future)
  • Instructions & an EMF Sticker
    • They are also greaseable so you can just pump a couple squirts of grease into it around every oil change and go.

      The Turbo Diesel Register has covered the subject and the most recent article was in Issue 91, pages 16-18. The conclusion: Make your first ball joint replacement your last.


Write a review
Buy Em
Oct 16, 2020  |  By Adam
These Ball joints are great. Don't waste your time installing Moog or something else. The support from EMF is fantastic too. 10/10 would buy again, but I'll never have to. I'll just rebuild them :)

Install and Tech Information